Using the backup and restore utility, Using the backup and restore utility” on, Figure 118 – Nortel Networks BCM200/400 User Manual
Page 256
256
Chapter 20 Preparing hardware for maintenance or upgrades
N0060612
N0060612
Figure 118 Install the BCM400 top cover
Using the backup and restore utility
The backup and restore utility (BRU) provides a means to preserve the integrity of your BCM
system operating system software and configuration data.
Use the BRU if you need to replace the following hardware:
•
Hard disk (see
“Replacing the hard disk” on page 261
)
•
Media Services Card (MSC) (see
“Replacing data cards and processing hardware” on page
)
Before you perform any substantial maintenance on the BCM system, save your data to a safe
storage module location elsewhere in the network. After hardware maintenance is complete,
restore the data to your BCM system. Access the BRU through the Element Manager main page.
For further instructions about how to operate the BRU, refer to the BCM 4.0 Administration Guide.
Slide cover
into place
1
Press cover
down
2
Install the top
cover screws
3