Nortel Networks BCM200/400 - Manual (Page 250)

250 Chapter 20 Preparing hardware for maintenance or upgrades
N0060612 N0060612
7 Grasp the advanced function tray latches and partially remove the unit from the main unit. Do
not exert force on the hard disk power cables and connectors.
8 Disconnect hard disk power cable connectors.
9 Disconnect the IDE connector.
10 Remove the advanced function tray completely from the main unit.
11 Place the advanced function tray on a flat, clean, and static-free surface. If you need to remove
the hard disk component, refer to “Removing a hard disk cage from a BCM400 advanced
function tray” on page 268 .
Figure 113 Remove the advanced function tray
Unfasten advanced function
tray latch screws
1
Slide advanced function tray partially away
from the main unit
3
2
4
Disconnect IDE cable from I/O
card
5
Disconnect power cables from the
hard disk or RAID card
Move advanced function tray latches to
the unlocked position