Nortel Networks BCM200/400 - Manual (Page 277)

Chapter 22 Replacing the hard disk 277
BCM200/400 4.0 Installation and Maintenance Guide
To install a hard disk into a standard configuration hard disk
cage
1 Position the hard disk into the bottom position of the hard disk cage.
2 Align the hard disk and hard disk cage retaining screw holes. Fasten the hard disk cage retainer
screws into both sides of the hard disk cage (see
Figure 131 ).
Figure 131 Install a single hard disk in the standard configuration hard disk cage
Installing a primary hard disk into a RAID hard disk cage
Use this procedure to install a primary hard disk into the RAID hard disk cage for the BCM200 or
BCM400 system. Use this procedure if you need to replace a faulty primary hard disk or install a
programmed hard disk from a standard configuration.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Note: For a BCM200 system, orient the hard disk so that the power and IDE connectors
are on the bottom and opposite to the hard disk cage lift tab (see
Figure 131 ).
For a BCM400 system, orient the hard disk so that the power and IDE connectors are on
the bottom and on the same side as the hard disk cage lift tab.
Align and install the
hard disk retainer
screws
Insert the hard disk into the
hard disk cage
1
2
Front view
Rear view
Hard disk
cage lift
tab
IDE connector
Power supply
connector
Note : Install the BCM200 hard disk so that the IDE and power
connectors are opposite to the hard disk cage lift tab
BCM200 shown