Nortel Networks BCM200/400 - Manual (Page 209)

Chapter 16 Using Element Manager to set the basic parameters 209
BCM200/400 4.0 Installation and Maintenance Guide
4 Configure the IP Terminal Global Settings attributes (see Table 75 ).
You can configure other attributes on the IP Terminal Global Settings tab depending on the
requirements for your system.
To configure SNMP settings
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3 Select the General tab. It is normally selected by default.
4 Click Modify in the SNMP Settings area. The Modify SNMP Settings dialog box opens.
Table 75 IP Terminal Global Settings attributes
Attribute Description
Enable registration Select this check box to allow new IP clients to register with the system.
WARNING: Remember to clear this check box when you have finished
registering the new telephones.
Enable global registration
password If you want to require the installer to enter a password when IP telephones are
configured and registered to the system, select this box.
If this box is not selected (disabled), a valid Telset user ID and password is
required to register IP phones.
Global password If the Enable Global Registration Password check box is selected, enter the
password the installer enters on the IP telephone to connect to the system.
If this check box is left clear, no password prompt occurs during registration.
Auto-assign DNs If this check box is selected, the system assigns an available DN as an IP
terminal requests registration. It does not prompt the installer to enter a set
DN.
If this check box is clear, the installer receives a prompt to enter the assigned
DN during the programming session.
Advertisement/Logo Any information in this field appears on the display of all IP telephones. For
example, your company name or slogan (24 characters in length).
Tip: To automatically configure IP Phones with DNs assigned:
1) Select the Enable registration check box.
2) Select the Enable global registration password check box.
3) Leave the Global password field blank.
4) Select the Auto-assign DNs check box.
After the IP Phones are operational, clear the Enable registration check
box.