Nortel Networks BCM200/400 - Manual (Page 174)

174 Chapter 10 Installing telephones and peripherals
N0060612 N0060612
T7406 cordless telephones use the DNs for the ports on the station module that is connected to the
base station. They are digital sets and use M7310/T7316 as an operational model.
Moving telephones
You can move a BCM digital telephone to a new location within the system without losing its
programmed settings, if the telephone has been enabled with Set relocation (automatic telephone
relocation). When you enable Set relocation, the internal numbers, auto-dial settings, and personal
speed dial codes remain with the telephone when you disconnect the telephone.
If you connect a different telephone to the jack before you reconnect the moved telephone, the new
telephone takes the programmed settings. The BCM system can no longer identify the old
telephone.
After you plug a moved set into a new jack, the BCM system can take 45 seconds to identify the
telephone. Programming relocation takes 3 minutes to complete. Wait for this to occur before you
change any settings for the telephone in the system.
For IP telephones to retain DN-specific features, the Keep DN Alive setting for the telephone
programming must be selected.
I
Warning: If you disconnect a relocated telephone before the relocation programming is
complete, the telephone can lose the programmed settings.
Note: Automatic telephone relocation is disabled by default.