Nortel Networks BCM200/400 - Manual (Page 123)

Chapter 8 Installing a media bay module (MBM) 123
BCM200/400 4.0 Installation and Maintenance Guide
Setting MBM DIP switches
Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of
these settings either on the chart shown in
Table 28 or in the Programming Record form.
To set MBM DIP switches
1 Locate the DIP switches on the MBM. See Figure 71 .
Figure 71 MBM DIP switches
2 Set the switches to correspond with the settings you chose in the procedure “To determine
MBM DIP switch settings” on page 118 .
3 Repeat step 2 for each MBM you want to install.
Note: The GASM and GATM MBMs have a different DIP switch configuration
than shown in
Figure 71 .
6 5 4 3 2 1 Off
On
Underside of the
MBM
DIP switches
Back of the MBM
1 2 3 4 5 6 On
Off
Rear view of the MBM
MBM is
right-side up