Nortel Networks BCM200/400 - Manual (Page 153)

Chapter 9 Connecting the cables 153
BCM200/400 4.0 Installation and Maintenance Guide
To connect the DSM16+, DSM32+, ASM8, GASM8, 8x16, or 4x16
MBMs
1 Wire 16 wire pairs from the amphenol connector to the local connecting blocks so they
connect to the 16 station sets you want connected to this MBM.
Table 51 provides the wiring scheme for the DSM16+, 4x16, 8x16, and DSM32+ MBMs. The
sets heading indicates the set numbering for each of the amphenol pairs. Set DNs are allocated
by the BCM system based on the DS30 bus setting on the station MBM. The upper 25-pair
connector of the G4x16 and G8x16 comprise the DSM16 part and is wired the same as the
DSM16.
Note: Use 16 wire pairs from each connector for the DSM 32.
Note: If you are connecting a DSM16+, 8x16, 4x16, or DSM32+, use Table 51 . If you are
connecting an ASM8 or GASM8, use Table 52 .