Nortel Networks BCM200/400 - Manual (Page 94)

98 Chapter 6 Installing the BCM main unit
N0060612 N0060612
Figure 57 Fasten the expansion unit to the equipment rack
Installing the main unit on the wall
This procedure describes how to mount the BCM200 or BCM400 main unit to a wall.
To mount the main unit on the wall, you need:
• a wall-mount bracket kit NTAB3422
• four #10 x 2.5 cm (#10 x 1 in.) round-head wood screws
• a plywood backboard 2 cm (3/4 in.) thick
To mount the expansion unit on the wall, you need:
• a wall-mount bracket (supplied with the unit)
• two #10 x 2.5 cm (#10 x 1 in.) round-head wood screws
• a plywood backboard 2 cm (3/4 in.) thick
To install the main unit on the wall
1 Mark the location of the plywood backboard on the wall using a pencil. Use a ruler and
bubble-level to check that the plywood backboard is level with respect to the wall.
2 Mount the plywood backboard securely to the wall.
Caution: Refer to “Environmental requirements” on page 89 for acceptable
environmental conditions before selecting a location for the BCM main unit.
Note: Nortel does not recommended use of the rack-mount brackets for wall-mount
applications.