Nortel Networks BCM200/400 - Manual (Page 68)

68 Chapter 2 Introducing the BCM hardware
N0060612 N0060612
Figure 40 BCM400 redundant power supply and modules
Figure 41 BCM400 redundant power supply connectors
In addition, international (non-North American) users require a power supply adapter cord for
each main unit and expansion unit.
Power supply module
removed from the redundant
power supply unit
Power supply module
inserted in the
redundant power
supply unit
Connector Configuration for
Redundant Sparkle Power Supply
Cable Lengths and
Markings
550mm (P2)
550mm (P3)
325mm to first
(P4), +50mm to
next (P5),
+100mm to last
(P6) (total 475mm)
340mm to first
(P7)(right angle) ,
+150mm to next
(P8) (total 490mm)
515mm (P1)
515mm (P9)
515mm (PA)
300mm (PB)
Route to Media bay backplane 1: Tie any slack at
the connector (behind the MBM).
Route to Media bay backplane 2: Tie any slack at
the connector (behind the MBM).
To hard disk: Tie any slack at the power supply. Tuck
any loose connectors under the hard disk cage.
Unused. Tie to the center of the hard disk cage.
Route to the I/O card.
Route to the I/O card.
Route to the I/O card.
Unused
Purpose and Notes