Nortel Networks BCM200/400 - Manual (Page 198)

198 Chapter 15 Using Telset Administration to set the basic parameters
N0060612 N0060612
To select the telephony startup template and start DN
You set the template and start DN using Feature **STARTUP from a two-line display telephone.
Refer to the BCM 4.0 Telset Administration Guide for information on using Telset Administration
to set this parameter.
Other telephony startup parameters are configured using Feature **CONFIG. Refer to the BCM
4.0 Telset Administration Guide for more information.
To initialize voice mail
You initialize your voice mail system using Feature 983 from a two-line display telephone.
Refer to the CallPilot Telephone Administation Guide for information on using Telset
Administration to initialize your voice mail system.
To create Telset user accounts
1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select User Accounts.
Note: You can only set these parameters for only 15 minutes after system bootup.
Note: When port 0101 is disabled, the Voice mail service does not start. To
enable port 0101, use the following procedure:
1 Open BCM Element Manager.
2 From the Configuration tab, click the Resources folder to expand it.
3 From the Resources folder, select Telephony Resources.
4 In the Modules section, click Bus 1 row.
5 Click the Set Port Details tab.
6 To enable port 0101, select the port and click Enable.
Note: You can only create Telset accounts using Telset Administration. To
create Element Manager accounts, you must use Element Manager.