Nortel Networks BCM200/400 User Manual
Page 199
Chapter 15 Using Telset Administration to set the basic parameters
199
BCM200/400 4.0 Installation and Maintenance Guide
4
Press OK. The Accounts screen appears.
5
Press NEXT to scroll through the list of available accounts to create.
6
Press CHNGE to change the status of the current account.
7
Press CRT to create the account.
If you see the DEL command instead of the CRT command, then the account is already
created.
8
Press BACK. The Accounts screen appears.
9
Press NEXT. The password screen appears.
10 Press CHNGE to change the password.
11 Press NEXT to scroll through the list of available accounts.
12 Press CHNGE to change the password for the selected account.
13 Enter the new password for the account.
14 Enter the new password again to confirm it.
“To create user accounts” on page 211
for more information on creating user accounts
using Element Manager.
Next step
After you configure the initial parameters using Telset Administration, you must configure the
startup parameters using Element Manager. Refer to
“Configuring the startup parameters” on page
for more information.