Record, Dsmc2 helium operation guide, Record via hd-sdi or hdmi – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual
Page 56: Simultaneous record

RECORD
Perform one of the following actions to begin recording:
Press
PWR/REC
on the camera.
Press
REC
on the media bay.
Press
START/STOP
on the DSMC2 Top Handle or DSMC2 Outrigger Handle.
Trigger start/stop with a compatible third-party trigger.
Double-tap the right 25% on an attached touchscreen display (when enabled).
NOTE:
To enable Double-Tap Right 25% to Record, go
RECORD VIA HD-SDI OR HDMI
NOTE:
Audio is not embedded in the MON-1 signal.
This section describes how to record via HD-SDI or HDMI through simultaneous record (recording to an SSD and an
external recorder at the same time) or external record only.
SIMULTANEOUS RECORD
NOTE:
HD-SDI and HDMI ports are only available on select DSMC2 expanders and modules. For more information,
go to
"Input/Output Connectors" on page 218
.
NOTE:
The secondary LCD/EVF port and an HDMI/MON-1 port cannot be used at the same time. Go to
.
You can record simultaneously to an external recorder and a RED SSD. To record simultaneously, follow the
instructions below:
1. Attach a DSMC2 expander or module that has an HD-SDI or HDMI port.
2. Connect the camera to an external recorder with an HD-SDI or HDMI cable.
3. Ensure that a formatted SSD is inserted in the camera.
4. Set up the HD-SDI or HDMI output:
A. Go to
Menu
>
Monitoring
>
Monitors
and select a monitor.
B. Select
Clean
from the
Mode
drop-down menu (otherwise the external recorder records the overlay).
C. Select the output resolution from the
Resolution
drop-down menu.
NOTE:
The HDMI and HD-SDI maximum resolution is 1080p. For more information, go to
.
5. Disable all False Colors (otherwise the external recorder records the False Colors). For more information, go to
6. If monitoring audio via a third-party monitor that supports audio, set up the monitor mix:
A. Go to
Menu
>
Settings
>
Audio
>
Mix
>
Monitor Mix
.
B. Adjust the input channels.
7. Go to
Menu
>
Settings
>
Recording
>
Mode
.
8. Select
Local
from the
Storage
drop-down menu.
9. Begin recording.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M
|
5 6
DSMC2 HELIUM OPERATION GUIDE