RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) - Manual (Page 28)

DSMC2 PRODUCTION MODULE (V-LOCK)
Figure: DSMC2 Production Module (V-Lock)
Designed for professional shooting configurations, the DSMC2 Production Module (V-Lock) mounts directly to the
BRAIN and offers a comprehensive array of video, power, communication, and pro audio connections. Constructed
from lightweight and durable aluminum alloy, this module incorporates an industry standard V-Lock mount to power
your DSMC2 camera when using RED BRICK, REDVOLT-V, or other v-lock batteries.
The DSMC2 Production Module includes three (3) BNC video connectors for maximum monitoring flexibility on-set.
Two (2) connectors output a cloned 3G-SDI signal, and one (1) connector serves as an independent monitoring output.
To support production demands for on-board monitors, wireless video transmitters, wireless lens control, and focus
assist systems, the module includes multiple auxiliary power outputs:
Two (2) front-facing 3-Pin Fischer R/S ports support Remote Start/Stop functionality, and provide 24V power out
up to a combined 2.5 Amps.
A front-facing2-Pin 0B AUX PWR port provides power out up to 3.0 Amps.
A 2-Pin P-Tap connector on the top provides power out up to 3.0 Amps.
A rear-facing USB 2.0 port with support for fast charging offers 5V at 1.5 Amps for powering small mobile devices.
Two (2) standard XLR connections are included for most professional audio needs. Each XLR input features a 3-
position selector switch to designate the incoming audio signal type: Balanced Line Level, Balanced Mic Level, and
Balanced Mic with +48V phantom power. Additionally, a 3.5mm line-level headphone jack allows users to monitor
audio during takes and in playback mode.
The module features ports for power in (DC IN), Genlock (BNC), 5-Pin 0B Timecode port, GIG-E, and CTRL.
The module also features a selector switch that enables the BRAIN to automatically boot when power is provided via
the DC IN connector on the module. This feature allows operators to use a connected DC input supply to turn the
BRAIN on and off when the camera is mounted in remote or difficult to maneuver locations.
NOTE: The battery plate on the DSMC2 Production Module is always enabled, regardless of the Auto Boot on Power
switch position.
NOTE: Only one (1) module can be used at a time.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC 9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M | 2 8
DSMC2 HELIUM OPERATION GUIDE