Dsmc2 helium operation guide – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual
Page 128
ENABLE MULTI-SHOT MODE
To enable Multi-Shot mode, follow the instructions below:
1. Set the camera to Stills mode. For more information, go to
2. Go to
Menu
>
Settings
>
Recording
>
Mode
.
3. Select
Multi-Shot
from the
Mode
drop-down menu.
4. Use the
Limit Recording to
fields to set the recording to end at a predefined frame limit (optional).
5. Close the menu.
MOTION + STILLS
NOTE:
This mode is available in Motion mode, but is only recommended in Stills mode.
Motion + Stills mode is identical to Continuous Record, except that when you initiate recording by pressing the
PWR/REC key on the camera, all other Record keys mark frames for the duration of the clip. (If you initiate recording
by pressing any other Record key, you can press any key mapped to “Record: Mark Frame” to mark stills.)
To use Motion + Stills mode, follow the instructions below:
1. Set the camera to Stills mode. For more information, go to
2. Go to
Menu
>
Settings
>
Recording
>
Mode
.
3. Select
Motion + Stills
from the
Mode
drop-down menu.
4. Use the
Limit Recording to
fields to set the recording to end at a predefined frame limit (optional).
5. Close the menu.
6. Press the
PWR/REC
key on the camera to start recording.
7. Press the
Record
key on the media bay to mark a frame.
8. Press the
PWR/REC
key on the camera to stop recording.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M
|
1 2 8
DSMC2 HELIUM OPERATION GUIDE