Set up stereo/3d configuration, Dsmc2 helium operation guide, Required cables – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual

Page 182

SET UP STEREO/3D CONFIGURATION

NOTE:

Master/Slave operation requires a GIG- E port, which is available on the DSMC2 Jetpack- SDI Expander,

DSMC2 REDVOLT Expander, and DSMC2 Production Module. For more information, go to

This section describes basic procedures for connecting two (2) cameras in a Master/Slave configuration for 3D
operation.

NOTE:

When providing the signals to a Stereo Image Processor (SiP) for verifying 3D alignment, set the HD-SDI

monitor output on both cameras to have the same overlay configuration.

NOTE:

For genlock to function correctly, the cameras must be on the same firmware version, and must be using the

same project time base and recording frame rate.

To set up a Stereo/3D setup, follow the instructions below.

1. On both cameras, set the project time base and recording frame rate.

2. On both cameras, follow the instructions in

to achieve Sensor Sync genlock status.

The

GEN

and

SYNC

indicators in the Lower Status Row illuminate green.

3. Follow the instructions in

to set Master and Slave camera settings.

4. On both cameras, follow the instructions in

set up media and camera settings.

REQUIRED CABLES

Use one (1) per camera:

75 ohm BNC cable (such as the RED HD-SDI Cable, P/N 790-0341)

Use one (1) per setup:

790-0163

: Master/Slave Gig-E Cable (4')

9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M

1 8 2

DSMC2 HELIUM OPERATION GUIDE