Dsmc2 helium operation guide – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual
Page 126

REDCODE BURST
NOTE:
This mode is not available in Stills mode.
NOTE:
Audio is not recorded in REDCODE Burst mode.
In REDCODE Burst mode, the camera can record at a lower compression (REDCODE) for the specified amount of
frames. When REDCODE Burst mode is enabled and recording starts, the camera captures a “burst” of frames at the
lower REDCODE, and then continues to record at the next available REDCODE. To add more bursts to clips during
recording, press any key mapped to “Record: Mark Frame”.
To use REDCODE Burst mode, follow the instructions below:
1. Go to
Menu
>
Settings
>
Recording
>
Mode
.
2. Select
REDCODE Burst
from the
Mode
drop-down menu.
3. Use the
Limit Recording to
fields to set the recording to end at a predefined frame limit (optional).
4. Select a
Pre Count
and
Post Count
. For more information, go to
"Pre Count and Post Count" below
.
5. Close the menu.
6. Start recording.
Figure: REDCODE Burst
PRE COUNT AND POST COUNT
When Frame Trigger or Burst mode is enabled, select the number of frames for the Pre Count and Post Count:
Pre Count
: The camera captures the frame cache from the time preceding the marker.
Post Count
: The camera captures the remaining frame cache after the marker.
The maximum frame counts are listed in the Available column, and are based on format and REDCODE.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M
|
1 2 6
DSMC2 HELIUM OPERATION GUIDE