Dsmc2 helium operation guide, Gpio sync – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual
Page 149
GPIO SYNC
NOTE:
Using general purpose inputs/outputs and sync requires an expander or module. For more information, go to
"Input/Output Connectors" on page 218
.
SYNC
Use the Sync menu to set up genlock and Motion Control (MoCo). For more information, go to
Multi-Camera Setup" on page 172
NOTE:
Using sync and genlock requires an expander or module. For more information, go to
.
SENSOR SYNC MODE
Sensor Sync Mode allows the shutter timing (scan start) to sync to an external signal.
Off
: Sensor runs at the current recording frame rate. This is the default option.
Genlock
: Sensor synchronizes with the incoming compatible genlock signal.
MoCo
: Each rising edge on the sync input triggers a frame to be captured.
GENLOCK SOURCE
Select a genlock input:
BRAIN (Default)
Rear Module
BRAIN GPIO
NOTE:
Using general purpose inputs/outputs and sync requires an expander or module. For more information, go to
"Input/Output Connectors" on page 218
.
GPI Function (Camera Input)
: Select one (1) of the following options to configure the input for devices connected
to the SYNC connector on the camera:
Sync In
: The camera input is used as a sync-in signal for MoCo.
General Purpose In
: Use the BRAIN GPI In High/Low drop-down menus to map inputs to actions.
GPO Function (Camera Output)
: Select an option to configure the output for devices connected to the CTRL
connector on the camera:
Sync Out
: Provides an output sync signal to act as a shutter start tally.
Recording Indicator Out
: Provides a signal when recording is in process.
GEN AND SYNC STATUS INDICATORS
The Lower Status Row of the camera display has GEN and SYNC indicators, which change color based on the current
genlock and sync statuses. For more information, go to
"Project Status Indicators" on page 68
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M
|
1 4 9
DSMC2 HELIUM OPERATION GUIDE