beautypg.com

Dsmc2 helium operation guide, Power out, Low voltage warning – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual

Page 104

background image

LOW VOLTAGE WARNING

When the Low Voltage Warning is enabled and the incoming voltage is less than the level you select, the camera
shows a warning message and the Power Status indicator in the Lower Status Row turns red. This warning gives you
the opportunity to change the battery or prepare for the camera to lose power. The warning continues to show until the
incoming voltage is equal to or higher than the level you select.

RED does not recommend a specific voltage threshold, since that depends on the power draw of the attached

accessories.

To enable the Low Voltage warning, follow the instructions below:

 1. Go to

Menu

>

Power

.

 2. Select the

Low Voltage Warning

check box.

 3. Select the voltage level threshold. The camera warns you when the incoming voltage is less than this level.

Figure: Low Voltage Warning

POWER OUT

The Power Out menu shows the status of the power out ports on the attached devices. The statuses are:

N/A

: The device is not present.

OK

: The power out port is functional.

FAULT

: A short or overcurrent tripped the electronic fuse. Remove the device that is connected to the port, as it

may be drawing too much power. Select

RESET

to clear the fault.

When the DSMC2 REDVOLT Expander is attached, you can see the current output of each power out port (in amps),
and toggle those ports on/off.

C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC

9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M    

|

   1 0 4

DSMC2 HELIUM OPERATION GUIDE