Dsmc2 helium operation guide, Set up internal timecode, Output timecode – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual
Page 173: Required cable

SET UP INTERNAL TIMECODE
To set up and adjust timecode generated by the camera, follow the instructions below:
1. Go to
Menu
>
Settings
>
Project
>
Timecode
.
2. Select the desired
Timecode Display
mode.
3. Set
Source
to
RTC
.
The
TC
indicator in the Lower Status Row remains grey when internal timecode is enabled.
Figure: Timecode
OUTPUT TIMECODE
NOTE:
Outputting timecode from the camera requires a DSMC2 REDVOLT Expander or DSMC2 Production Module.
To output a timecode signal to an external device or slaved camera, follow the instructions below:
1. Follow the instructions in
"Set Up Internal Timecode" above
to set up internal timecode.
2. Connect the camera to another device using the PRO I/O TIMECODE CABLE (3').
A. Connect one connector to the
TIMECODE
port on the expander or module.
B. Connect the other connector to an external device or camera.
REQUIRED CABLE
790-0212
: PRO I/O TIMECODE CABLE (3')
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M
|
1 7 3
DSMC2 HELIUM OPERATION GUIDE