RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) - Manual (Page 24)

THIRD-PARTY BATTERY COMPATIBILITY
To be compatible with the DSMC2 V-Lock I/O Expander, third-party batteries must meet these requirements:
Maximum width: approximately 100.6 mm
Minimum radius of the side edge of the V-mount (rear mounting surface): approximately 9.70 mm
The following third-party batteries have been fit-tested by RED and are mechanically compatible with the DSMC2 V-
Lock I/O Expander (additional batteries may be compatible, but have not been tested):
Blueshape ® (All BV series)
IDX ® (E-HL10DS and E-HL9)
Sony ® (BP-FL75)
Switronix (Hypercore series and XP-L90S)
WARNING: While third-party batteries may be mechanically compatible with the camera system, the manufacturer is
responsible for the performance and stability of third-party options, not RED. Damage to the camera system or third-
party devices caused by using third-party power options is not covered under warranty. The camera may be unable to
determine and display the voltage or remaining battery capacity of third-party power options.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC 9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M | 2 4
DSMC2 HELIUM OPERATION GUIDE