beautypg.com

Master/slave operation, Dsmc2 helium operation guide – RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) User Manual

Page 177

background image

MASTER/SLAVE OPERATION

NOTE:

Master/Slave operation, including stereo/3D and camera arrays, requires a GIG-E port, which is available on the

DSMC2 Jetpack-SDI Expander, DSMC2 REDVOLT Expander, and DSMC2 Production Module. For more information,
go to

"GIG-E (Ethernet)" on page 237

.

NOTE:

The Master camera controls metadata and basic camera parameters of the Slave cameras. Any other setting

changes required by the Slave cameras must be made before recording.

This section describes operation in Master/Slave configuration and clip naming conventions for clips recorded on
those cameras. Master/Slave is the most common configuration for Stereo/3D productions.

When cameras are operated in Master/Slave configuration, you can perform the following operations:

Power

: Turn off the Master camera to turn off both cameras.

Record

: Press the

PWR/REC

key on the Master camera to start/stop recording on both cameras.

Change settings

: Change settings on the Master camera, to change settings on the Slave camera.

For a Master/Slave configuration to function, the cameras must have the same:

Firmware version

Project time base

Recording frame rate

BRAIN

Sensor

C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC

9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M    

|

   1 7 7

DSMC2 HELIUM OPERATION GUIDE