RED DIGITAL CINEMA DSMC2 BRAIN with HELIUM 8K S35 Sensor (2018 Unified DSMC2 Lineup) - Manual (Page 13)

C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC 9 5 5 - 0 1 6 8 _V 7 .1 , R EV - M | 1 3
DSMC2 HELIUM OPERATION GUIDE
CHAPTER 2:
CAMERA SYSTEM COMPONENTS
NOTE: Modules, expanders, and lens mounts are NOT HOT SWAPPABLE, meaning you cannot remove or install
these items while the camera is turned on. Before installing or removing these items, you MUST turn off the camera.
Failure to do so may result in damage to the item or camera that is not covered under warranty.
NOTE: Availability of components listed in this chapter is subject to change at any time.
ADDITIONAL RESOURCES
For more information on power and media, see the following guides, available at www.red.com/downloads :
DSMC Power Operation Guide
DSMC Media Operation Guide
BRAIN
Figure: DSMC2 HELIUM with DSMC S35 Canon Mount
The DSMC BRAIN ® is the image processing center of the camera system and supports power, media, and other
modules.
The only ports on the BRAIN are the DSMC2 ® Top Handle port and EVF/LCD ports. A port expander or power
module is required to power the camera. All other input/output (I/O) ports are available only via expanders and other
modules. This modular approach allows you to customize your camera and make use of the ports that are most
applicable to your needs.
The RED ® Tactical Hand Controller (T.H.C.) cannot pair directly to the camera. To use the T.H.C. with the camera, the
T.H.C. needs to be connected to the W.M.D. (either wired or wirelessly). For more information about the T.H.C., see
the
RED 3-Axis System Operation Guide at www.red.com/downloads .