Yaskawa DR2 Sigma Servo - Manual (Page 183)

USING THE DIGITAL OPERATOR
4.1.1 Connecting the Digital Operator
170
4.1 Basic Operations
This section describes the basic operations using the Digital Operator.
4.1.1 Connecting the Digital Operator 170 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.2 Resetting Servo Alarms 171 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.3 Basic Functions and Mode Selection 172 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.4 Operation in Status Display Mode 173 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.5 Operation in User Constant Setting Mode 176 . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.6 Operation in Monitor Mode 179 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.1.1 Connecting the Digital Operator
The applicable Digital Operator type is JUSP-OP02A-1 (Hand-held Type) .
Hand-held type is connected to the Servopack as shown below.
JUSP-OP02A-1 (Hand-held Type)
Connect using the 1 m
cable supplied.
Servopack
· The Digital Operator connector can be connected or disconnected while the Servopack
power is ON.
Note Mount type digital operator (JUSP-OP03A)
cannot be used.
Type: JUSP-OP03A
4