Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 86)

86 K2 Media Client User Manual June 5, 2009
Chapter 5 Playing and editing clips
3. To rename the subclip, click the subclip name control , and
enter the new name in the Clip Name dialog, then click OK , or press Enter .
Renaming the subclip creates a new seed name. For example, if you rename the
subclip PlayoffGame-1 to Highlight, subsequent subclips created are named
Highlight-1, Highlight-2, and so on.
4. Enter the subclip marks as follows:
a. Using the transport controls, position the clip to the desired frame for mark-in,
then click the In button.
b. Using the transport controls, position the clip to the desired frame for mark-out,
then click the Out button.
Alternatively: Select the mark-in or mark-out timecode entry controls and enter
a specific timecode value.
Alternatively: Select the Length timecode entry control and enter a clip length,
then create either a mark-in or a mark-out point. If the source media has been
erased, the subclip retains 1 second of media on each side of the mark-in and
mark-out points.
See “Moving clip mark-in/mark-out points” on page 54 .
3. In Subclip view, click Accept .
The subclip is saved and ejected, then Player returns to Subclip view with a new
subclip name loaded.
NOTE: If the Accept button does not flash, but instead the clip is saved and a new
subclip is loaded, the server is in Auto-subclip mode. See “About Auto Subclip
mode” on page 60 .
NOTE: Clicking the Source Clip button or the Eject button prior to pressing the
Accept button closes Subclip mode without creating a new clip. Both of these
buttons are used to exit Subclip mode.
About Auto Subclip mode
The Auto-Subclip feature changes the way that the subclip mode behaves. Auto
Subclip mode eliminates the “Accept” step in the subclip procedure. In Auto-Subclip
mode, you simply set mark-in, then set mark-out. On setting mark-out, the subclip is
automatically generated and ejected, and a new subclip name is loaded in the Subclip
display.
Auto Subclip mode is useful when you want to create subclips while a source clip is
playing. You simply load a clip, press play, then create subclips by selecting In, Out,
In, Out, etc.
To enable Auto Subclip mode:
• In the Player application Control view , click Control | Auto Subclips .
Creating subclips in Cue view
In Cue view, you can automatically create a subclip from the selected cue point. The
selected cue point becomes the mark-in point, while the mark-out point is the same as
the source clip. If more than one cue point is selected, a subclip is created using the