Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 227)

June 5, 2009 K2 Media Client User Manual 227
GPI Input
GPI Input
On the GPI tab,
select
GPI-Input…
Make settings as needed…
GPI Input 1
.
.
.
GPI Input 12
Trigger
channel(s) R1, R2, P1, P2, P3
(HD-00, SDA-00)
or
C1, C2, C3, C4
(SD-00) Select the channel to trigger the GPI input.
GPI Input 1
.
.
.
GPI Input 12
Trigger action Play Play current loaded clip or playlist in
assigned Player channel.
Record Start recording a clip in Recorder channel.
Stop Stop playback or record of assigned
channel.
Rewind Rewind playback of assigned channel.
Channel stays in rewind mode until the
beginning of clip is reached or another
transport action is taken.
Fast Forward Fast forward playback of assigned channel.
Channel stays in the fast forward mode until
the end of clip is reached or another
transport action is taken.
Cue Start Cue to start of clip loaded in Player or
Playlist channel.
Cue End Cue to end of clip loaded in assigned
channel.
Eject Ejects the current clip.
Preview The current clip in the record channel is
loaded in a play channel.
NOTE: You can use
Eject prior to Preview if a clip is already loaded
in the Play channel.
Cue Next Event Goes to next event in a Playlist and stops.
Cue Prev Event Goes to previous event in a Playlist and
stops.
Cue Next Section Goes to next section in a Playlist and stops.
Cue Prev Section Goes to previous section in a Playlist and
stops.
VAR Playback Plays loaded clip in VAR mode with pre-set
speed as set in
“Adjusting play speed
options” on page 192 (SDA-00) or page 205
(SD-00) or page 220 (HD-00).
GPI Input 1
.
.
.
GPI Input 12
Active High
Low
Select the active signal (high or low)
required. This is determined by the external
equipment connected to the GPI input.