Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 202)

202 K2 Media Client User Manual June 5, 2009
Chapter 11 SD-00: Audio/Video Configuration
Record channel audio setup
On the SD-00 K2 Media Client, channels are bi-directional, so the record and play
channel settings are both located on the same channel configuration page.
Available settings change depending on the audio input selected, as in the following
sections:
• “AES/EBU audio setup”
• “Embedded audio setup”
AES/EBU audio setup
To access record channel audio settings, open Configuration Manager, click Channel ,
and select a channel (C1, C2, C3, C4).
Automatic VITC
detection On Makes the following setting(s) available below:
Starting VITC line
Ending VITC line
Off Makes the following setting(s) available below:
VITC line 1
VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present Green LED indicates VITC is present.
Black LED indicates VITC is not present.
For this setting... Configure as needed…
Audio input type AES/EBU Makes settings available as documented in this table.
Number of audio
inputs 2 Makes the following setting(s) available below:
A1/A2 input format
4 Makes the following setting(s) available below:
A1/A2 input format
A3/A4 input format.
A1/A2 input format 16-bit PCM
24-bit PCM
AC-3
Dolby-E
A3/A4 input format
Timing offset Between -200ms and +200ms. The default value is 0 ms.
Audio Input Tags Add tags for languages or other purposes to this channel’s audio tracks. Refer
to
“Adding audio tags” on page 238 .
For this setting... Configure as needed…