Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 110)

110 K2 Media Client User Manual June 5, 2009
Chapter 6 Working with playlists
outputs to a channel that is running the Playlist application. If you want to play a list
that was created on another channel, you must ensure that GPI triggers assigned to all
applicable channels use the same names, otherwise the GPI triggers will not occur.
Using identical GPI naming also allows copying and pasting sections and events
between lists to be played on different channels.
To trigger GPI outputs:
1. Use Configuration Manager to assign GPI outputs to the current Playlist channel.
• Select System | Configuration . Make the changes to the GPI settings.
2. Select an event or section in the playlist, then open the properties dialog box by
doing one of the following:
• Click the Properties button.
• Right-click on an event or section and select Properties .
3. Select Trigger GPI, then use the drop-down list to select a GPI output. If no GPI
outputs are listed, use Configuration Manager to assign GPI outputs to the current
channel, then return to this step.
4. Select the trigger action for the GPI output:
Action Trigger point
Start of event or section First frame of event or section
End of event or section Last frame of event or section
Start plus Start of event or section plus the time you enter.
Offset should not exceed the event or section total
length.If the offset time entered exceeds the event
or section length, a warning message is displayed.