Long gop, Yes (ibpbpbpbpb), No (i-frame only) – Grass Valley K2 Media Client User Manual v3.3 User Manual
Page 187: Chroma format, Recording data rate, Compress vbi, Yes (active picture plus vbi), No (active picture only), Input type, Analog composite

June 5, 2009
K2 Media Client User Manual
187
MPEG compression format setup
Long GOP
Yes (IBPBPBPBPB)
No (I-frame only)
—
Chroma format
4:2:0
Makes the following setting(s) available below:
Recording data rate: 2-15 Mb/s
4:2:2
Makes the following setting(s) available below:
Recording data rate: 4-50 Mb/s
Compress VBI
Recording data
rate
Selectable, with range dependent on Chroma format selection above. Data rates
above 25 Mb/s are a licensable option.
Compress VBI
Yes (Active picture plus
VBI)
—
No (Active picture only)
—
Input type
SDI
—
Analog Composite
When the reference standard is NTSC and this
setting is selected, it makes the following
setting(s) available below:
Input pedestal
Input pedestal
On
If you are operating with a standard NTSC input
signal with 7.5 IRE setup, then make this
selection. You must make this selection for both
record channels.
Off
—
Automatic VITC
detection
On
Makes the following setting(s) available below:
Starting VITC line
Ending VITC line
Off
Makes the following setting(s) available below:
VITC line 1
VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present
Green LED indicates VITC is present.
Black LED indicates VITC is not present.
For this setting...
Configure as needed…