Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 71)

June 5, 2009 K2 Media Client User Manual 71
Guide to using Player: Control view
Guide to using Player: Control view
The Control view allows you to play a clip, modify its name, adjust mark in and mark
out points, create sub-clips, and stripe timecode. Selecting the
Control view tab shows
the Control view. The following describes the essential controls in the Control view.
Control Description and User Operation
1 Assignable Buttons Assignable buttons allow you to modify the button assignments to
best suit your workflow. Hold down a button to open a pop-up menu
that lists the alternative button choices.
2 Clip Timecode Indicates the recorded timecode of the current frame being played.
The timecode value of XX:XX:XX:XX is displayed when there is no
recorded timecode.
Stop mode is indicated by TC (recorded timecode) or Gen
(zero-based, internal generated timecode.).
3 Clip Name & Current Bin Displays the clip’s name and location in the video storage file
system. To rename the clip, click the Clip Name, then enter a new
name.
4 Countdown Timecode Displays the time remaining in the clip.
Clip
Timecode
Thumbnail
(Click to change
thumbnail)
View
Tabs 2 3 Clip Name &
Current Bin
(Click clip name
to rename.) Assignable
Buttons
(Default buttons
are shown) 1
7 Time Dome
(Click to select
loop-play mode)
5
Meter Bar
Button
(Click to adjust
audio level) Mark-In &
Mark-Out
(Click to set to
current frame
timecode) 8 9
Countdown
Timecode 4
Application 6 10