Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 58)

58 K2 Media Client User Manual June 5, 2009
Chapter 4 Recording clips
Before you record: Recorder settings checklist
Before recording, check the following recorder channel settings.
Record Channel Setting Procedure
Verify video and audio input selection In the monitor pane, check the thumbnail and its
audio level indicators to verify the correct record
channel inputs are selected. If there is a problem,
correct the settings.
Verify video compression data rate
You can manage storage capacity and
video quality by adjusting the record
channel compression data rate. Generally
set as high as possible to obtain the storage
capacity needed. Under the System menu, click Configuration .
Verify digital audio compression setting Under the System menu, click Configuration .
Verify the timecode source
Make sure to select a valid timecode
source. You can use the internal timecode
generator, VITC, or LTC. See “Changing the timecode source” on page 64 .
Verify widescreen mode setting
This setting only applies to SD clips. If the
SD video source is in widescreen format,
select widescreen mode for the recorder.
This attribute is saved with the clip. (720p
and 1080i clips recorded on the HD-00 K2
Media Client are always in widescreen,
whether this is selected or not.) In AppCenter main menu, click Control | Options |
Widescreen 16:9 to toggle widescreen mode.
NOTE: The clip aspect ratio cannot be
changed once the clip is recorded. If
you want to change the clip’s aspect
ratio attribute you must re-record the
clip.
Adjust audio level (if needed)
You can use the audio leveling feature to
adjust the analog or digital audio input
levels, excluding dolby encoded digital
audio.
1. In the Recorder pane, select the Meter bar
button.
2. Adjust audio level using the graphical
faders. Select the Meter bar button
again to return to Recorder view.
Verify audio monitor settings
You can select which audio channels to
monitor. Select Control | Options and click the Audio tab.