Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 216)

216 K2 Media Client User Manual June 5, 2009
Chapter 12 HD-00: Audio/Video Configuration
Recording data
rate
b
Between 2-15 Mb/s. If configured above as SD 4:2:0
Between 4-50 Mb/s. If configured above as SD 4:2:2
Between 12-80 Mb/s. If configured above as 720 4:2:0
Between 20-100 Mb/s. If configured above as 720 4:2:2
Between 20-80 Mb/s. If configured above as 1080 4:2:0
Between 20-100 Mb/s. If configured above as 1080 4:2:2
Select 25 or 35 Mb/s. If configured above as 1080 XDCAM-HD
Compress VBI Yes (Active picture plus
VBI) —
No (Active picture only) If “Record Uncompressed VBI and captioning
to data track:” is set to “No”, makes the
following setting(s) available below:
Uncompressed VBI lines
Uncompressed
VBI lines Select up to 6 lines. A line may be selected as either Luma or Chroma, but not
both.
Input type SDI HD-00 K2 Media Client is SDI only.
Video input Video input present Green LED indicates input is present.
Black LED indicates input is not present.
Ancillary data
timecode inputs Ancillary LTC
present
Ancillary VITC
present
Automatic VITC
detection On Makes the following setting(s) available below:
Starting VITC line
Ending VITC line
Off Makes the following setting(s) available below:
VITC line 1
VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present Green LED indicates VITC is present.
Black LED indicates VITC is not present.
a.
Changing video input format does not require a restart of the HD/SD K2 Media Client. If changing
between SD and HD, however, there is a wait time up to 24 seconds for each recorder channel after
clicking the OK button in Configuration Manager.
b. Grass Valley does not recommend low bit rates for HD I-frame MPEG.
For this setting... Configure as needed…