Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 61)

June 5, 2009 K2 Media Client User Manual 61
To record a clip
Specify clip length after recording has begun
While a clip is recording you can enter the clip length as follows:
1. Select Length in the Recorder pane.
The timecode dialog box appears.
2. Enter the desired length, then select OK or Enter .
If the entered length is valid, longer than the amount of material already recorded,
the clip continues to record until it reaches the specified length or until you select
Stop .
Using continuous record
You can configure Recorder for Continuous Record mode. Continuous record is
useful for applications that normally use Continuous Record, for example a manual
time delay. Refer to
“About recording clips” on page 50 .
1. Click the Time Dome .
The Time Dome pop-up menu appears.
2. Choose Continuous Record in the pop-up menu.
The Time Dome changes to display continuous record .
3. Click Length .
The Length dialog box appears.