beautypg.com

Still-play mode, Test mode (colorbars + tone), Video output timing – Grass Valley K2 Media Client User Manual v3.3 User Manual

Page 204: Line offset (coarse), Sample offset (fine), Vitc output generator, Vitc line 1, Vitc line 2, Play channel audio setup, Embedded output group(s)

background image

204

K2 Media Client User Manual

June 5, 2009

Chapter 11 SD-00: Audio/Video Configuration

To access play channel video settings, open Configuration Manager, click

Channel

,

and select a channel (C1, C2, C3, C4).

Play channel audio setup

On the SD-00 K2 Media Client, channels are bi-directional, so the record and play
channel settings are both located on the same channel configuration page.

To access play channel audio settings, open Configuration Manager, click

Channel

,

and select a channel (C1, C2, C3, C4).

For this setting...

Configure as needed…

Still-play mode

a

a.

Still-Play mode settings determine how to generate the still-play signal for the play channel when it is
setup to freeze on last frame of video in stop mode. You can select interpolated or interlaced.

Field
(interpolated)

This is the default setting and uses the content of one field for
both fields during still-play for a one field freeze. This mode
eliminates the motion jitter that can be present in Interlaced
mode.

Frame
(interlaced)

This mode displays two fields in still play mode for a two
field freeze. With this mode you might see some motion jitter
in still-play.

Test mode
(colorbars + tone)

On
Off

Temporarily displays 75% colorbar signal on the channel
output. It also generates an audio tone on all audio outputs.
This setting is for test purposes only, so it is not saved.

Video Output
Timing

Line offset
(coarse)

Delays the video output. Range: NTSC 0-524 lines; PAL
0-624 lines.

Sample offset
(fine)

Delays the video output. Range: NTSC 0-1715 clock
samples; PAL 0-1727 clock samples.

VITC output
generator

On

Makes the following setting(s) available below:

VITC line 1
VITC line 2

Off

VITC line 1

Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).

VITC line 2

Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).

For this setting...

Configure as needed…

Embedded output
group(s)

None
Groups 1, 2, 3, 4

Timing offset

Between -200 ms and +200 ms. The default is 0 ms.

Audio Output
Tags

Add tags for languages or other purposes to this channel’s audio
tracks. Refer to

“Adding audio tags” on page 238

.

Display audio
meters

Yes
No

Displays meters on the channel pane for audio level
monitoring.

This manual is related to the following products: