Gpi output, Chapter 13 gpi and other configurations – Grass Valley K2 Media Client User Manual v3.3 User Manual
Page 228

228
K2 Media Client User Manual
June 5, 2009
Chapter 13 GPI and other configurations
GPI Output
NOTE: If you want to play a list that was created on another play channel, you must
ensure that GPI triggers assigned to the play channels use the same names;
otherwise the GPI triggers will not occur. Using identical GPI names also allows
copying and pasting sections and events between lists.
On the GPI tab,
select
GPI-Output…
Make settings as needed…
GPI Output 1
.
.
.
GPI Output 12
Channel
None R1, R2, P1,
P2, P3 (HD-00,
SDA-00)
or
C1, C2, C3, C4
(SD-00)
Select the channel on which to trigger
the GPI Output.
GPI Output 1
.
.
.
GPI Output 12
Active
High
Low
Select the active signal (high or low)
required. This is determined by the
external equipment connected to the
GPI Output.
GPI Output 1
.
.
.
GPI Output 12
Control
(This menu and
the items on it
are part of the
licensable
AppCenter Pro
option)
Application
Position trigger
Channel state
Determines whether the GPI output is
triggered by the application (e.g., by the
Properties dialog box in Playlist), the
position (e.g. at the beginning or end of
a clip) or the state of the selected
channel (e.g. playing, recording, idle,
etc.)
GPI Output 1
.
.
.
GPI Output 12
Trigger name
(Available
when
Application
selected)
GPI-Out-X
Enter the name of the action triggered
by the GPI output.
GPI Output 1
.
.
.
GPI Output 12
Trigger at
(Available
when
Position
trigger
selected)
Start of material
End of material
Start of material plus
End of material
minus
When Start/End of material plus/minus
offset appears
GPI Output 1
.
.
.
GPI Output 12
Activate when
(Available
when
Channel
state
selected)
Playing
Recording
Cued for play
Cued for record
Idle
Once a channel has been selected, this
setting triggers the GPI output when the
channel is in the specified state.