Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 201)

June 5, 2009 K2 Media Client User Manual 201
MPEG:D10 compression format setup
MPEG:D10 compression format setup
To access record channel video settings, open Configuration Manager, click Channel ,
and select a channel (C1, C2, C3, C4).
Recording data
rate Selectable, with range dependent on Chroma format selection above. Data rates
above 25 Mb/s are a licensable option.
Compress VBI Yes (Active picture
plus VBI) —
No (Active picture
only) If “Record Uncompressed VBI and captioning to
data track:” is set to “No”, makes the following
setting(s) available below:
Uncompressed VBI lines
Uncompressed
VBI lines Select up to 6 lines. A line may be selected as either Luma or Chroma, but not
both.
Input type SDI SD-00 K2 Media Client is SDI only.
Video input
present Green LED indicates video input is present.
Black LED indicates video input is not present.
Automatic VITC
detection On Makes the following setting(s) available below:
Starting VITC line
Ending VITC line
Off Makes the following setting(s) available below:
VITC line 1
VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present Green LED indicates VITC is present.
Black LED indicates VITC is not present.
For this setting... Configure as needed…
Compression
format MPEG:D10 Selecting this format makes settings available as
documented in this table. MPEG:D10 is a licensable
option.
For other format settings, refer to
“DV compression
format setup” on page 200 and “MPEG compression
format setup” on page 200 .
Recording data
rate 30 Mb/s
40 Mb/s
50 Mb/s
Input type SDI SD-00 K2 Media Client is SDI only.
Video input
present Green LED indicates video input is present.
Black LED indicates video input is not present.
For this setting... Configure as needed…