Embedded audio setup, Audio input type, Embedded – Grass Valley K2 Media Client User Manual v3.3 User Manual
Page 190: Number of audio inputs, Embedded input group(s), Group 1, Group 2, Group 3, Group 4, A1/a2 input format

190
K2 Media Client User Manual
June 5, 2009
Chapter 10 SDA-00: Audio/Video Configuration
Embedded audio setup
To access record channel audio settings, open Configuration Manager, click
Channel
,
and select a record channel (R1, R2):
SDI embedded audio is supported on either the first two channels of a group or all four
channels from a single group.
Play channel video setup
NOTE: If you are using a channel suite with channels from multiple K2 Media
Clients, make sure that you have selected a channel from the K2 Media Client that
you want to configure before accessing Configuration Manager.
To access play channel video settings, open Configuration Manager, click
Channel
,
and select a play channel (P1, P2).
For this setting...
Configure as needed…
Audio input type
Embedded
Makes settings available as documented in this table.
Number of audio
inputs
2
Makes the following setting(s) available below:
A1/A2 input format
4
Makes the following setting(s) available below:
A1/A2 input format
A3/A4 input format.
Embedded input
group(s)
Group 1
Group 2
Group 3
Group 4
A1/A2 input format
16-bit PCM
24-bit PCM
AC-3
Dolby-E
A3/A4 input format
Timing offset
Between -200ms and +200ms. The default value is 0 ms.
Audio Input Tags
Add tags for languages or other purposes to this channel’s audio tracks. Refer
to
“Adding audio tags” on page 238
.
Display audio
meters
Yes
No
Displays meters on the channel pane for audio level
monitoring.
For this setting...
Configure as needed…
Output pedestal
On
This setting available only when the reference standard is set
to NTSC.
Off
Still-play mode
a
Field
(interpolated)
This is the default setting and uses the content of one field for
both fields during still-play for a one field freeze. This mode
eliminates the motion jitter that can be present in Interlaced
mode.
Frame
(interlaced)
This mode displays two fields in still play mode for a two
field freeze. With this mode you might see some motion jitter
in still-play.