Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 191)

June 5, 2009 K2 Media Client User Manual 191
Play channel audio setup
Play channel audio setup
To access play channel audio settings, open Configuration Manager, click Channel ,
and select a play channel (P1, P2).
Test Mode
(Colorbars + Tone) On
Off Temporarily displays 75% colorbar signal on the channel
output. It also generates an audio tone on all audio outputs.
This setting is for test purposes only, so it is not saved.
ProcAmp Control
(Composite
Output) Video gain Between 0 and 255. The default value is 128.
Chroma gain Between 0 and 255. The default value is 128.
Chroma
phase Between -127 and +128. The default value is 0.
Black level Between 0 and 15. The default value is 0.
Sharpness Between 0 and 12. The default value is 6.
Video Output
Timing Frame offset Delays video output. Range: NTSC 0-1 frames, PAL 0-3
frames.
Line offset
(coarse) Delays the video output. Range: NTSC (525 lines) 0-524
lines, PAL (625 lines) 0-624 lines.
Sample
offset (fine) Delays the video output. Range: NTSC (525 lines) 0-1715
clock samples, PAL (625 lines) 0-1727 clock samples.
Analog
sub-pixel
offset (SC) This setting applies to analog video only. Between 0 and 255.
The default value is 5.
VITC output
generator On Makes the following setting(s) available below:
VITC line 1
VITC line 2
Off —
VITC line 1 Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).
VITC line 2 Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).
a. Still-Play mode settings determine how to generate the still-play signal for the play channel when it is
setup to freeze on last frame of video in stop mode. You can select interpolated or interlaced.
For this setting... Configure as needed…
Embedded output
group(s) None
Group 1
Group 2
Group 3
Group 4
Timing offset Between -200 ms and +200 ms. The default is 0 ms.
For this setting... Configure as needed…