Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 109)

June 5, 2009 K2 Media Client User Manual 109
Adding GPI output triggers to playlists
5. Use the drop-down list to choose whether to Freeze on last frame, Freeze on next
event, Show black or Show E-to-E (if using the SDA-00 K2 Media Client).
6. Click OK .
Properties for each event currently in this section of the playlist are modified to
include the specified pause type. If you later add an event to this section and you
want it to have the same pause type, you must manually modify its properties.
Properties of events added later are not automatically modified.
During playback, each event will remain paused at its end until you intervene. The
pause symbol
appears in the corner of the event thumbnail.
To remove pause from all events in a section
To remove pauses at the end of all section events:
1. Select the section.
2. Open the properties dialog box by doing one of the following:
• Click the Properties button.
• Right-click on a section and select Properties .
3. Click All Events .
4. Select the Change event pauses check box, then choose the Remove all pauses
option.
5. Click OK .
Pauses are removed from all events in the section. The section now plays without
pausing between any events.
Adding GPI output triggers to playlists
You can assign GPI output triggers to events and sections in a playlist. The GPI
outputs can be used to trigger external equipment when the list plays. Before you can
use GPI output triggers in a list, you must use Configuration Manager to assign GPI