H3C Technologies H3C S10500 Series Switches User Manual
Page 89

78
[SwitchA-mpls] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] mpls
[SwitchA-Vlan-interface2] quit
# Configure MPLS on Switch B.
[SwitchB] mpls lsr-id 2.2.2.9
[SwitchB] mpls
[SwitchB-mpls] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] mpls
[SwitchB-Vlan-interface2] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] mpls
[SwitchB-Vlan-interface3] quit
# Configure MPLS on Switch C.
[SwitchC] mpls lsr-id 3.3.3.9
[SwitchC] mpls
[SwitchC-mpls] quit
[SwitchC] interface vlan-interface 3
[SwitchC-Vlan-interface3] mpls
[SwitchC-Vlan-interface3] quit
4.
Create a static LSP from Switch A to Switch C.
# Configure the LSP ingress, Switch A.
[SwitchA] static-lsp ingress AtoC destination 21.1.1.0 24 nexthop 10.1.1.2 out-label 30
# Configure the LSP transit node, Switch B.
[SwitchB] static-lsp transit AtoC incoming-interface vlan-interface 2 in-label 30 nexthop
20.1.1.2 out-label 50
# Configure the LSP egress, Switch C.
[SwitchC] static-lsp egress AtoC incoming-interface vlan-interface 3 in-label 50
5.
Create a static LSP from Switch C to Switch A.
# Configure the LSP ingress, Switch C.
[SwitchC] static-lsp ingress CtoA destination 11.1.1.0 24 nexthop 20.1.1.1 out-label 40
# Configure the LSP transit node, Switch B.
[SwitchB] static-lsp transit CtoA incoming-interface vlan-interface 3 in-label 40 nexthop
10.1.1.1 out-label 70
# Configure the LSP egress, Switch A.
[SwitchA] static-lsp egress CtoA incoming-interface vlan-interface 2 in-label 70
6.
Verify the configuration.
# Execute the display mpls static-lsp command on each switch to view the static LSP information. The
following takes Switch A as an example:
[SwitchA] display mpls static-lsp
total statics-lsp : 2
Name FEC I/O Label I/O If State
AtoC 21.1.1.0/24 NULL/30 -/Vlan2 Up
CtoA -/- 70/NULL Vlan2/- Up