beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 387

background image

376

[PE1-LoopBack0] isis enable 1

[PE1-LoopBack0] quit

[PE1] interface vlan-interface 12

[PE1-Vlan-interface12] ip address 30.1.1.1 24

[PE1-Vlan-interface12] isis enable 1

[PE1-Vlan-interface12] mpls

[PE1-Vlan-interface12] mpls ldp

[PE1-Vlan-interface2] mpls ldp transport-address interface

[PE1-Vlan-interface2] quit

[PE1] bgp 100

[PE1-bgp] peer 4.4.4.9 as-number 100

[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0

[PE1-bgp] ipv4-family vpnv4

[PE1-bgp-af-vpnv4] peer 4.4.4.9 enable

[PE1-bgp-af-vpnv4] quit

[PE1-bgp] quit

NOTE:

The configurations for PE 2 are similar to those for PE 1.

After completing the configurations, issue the display mpls ldp session command on PE 1 or PE 2; the

output shows that the LDP session has been established successfully. Issue the display bgp peer command;

the output shows that a BGP peer relationship has been established and has reached the Established
state. Issue the display isis peer command; the output shows that an IS-IS neighbor relationship has been

set up. Take PE 1 as an example:

[PE1] display mpls ldp session

LDP Session(s) in Public Network

Total number of sessions: 1

----------------------------------------------------------------

Peer-ID Status LAM SsnRole FT MD5 KA-Sent/Rcv

----------------------------------------------------------------

4.4.4.9:0 Operational DU Active Off Off 378/378

----------------------------------------------------------------

LAM : Label Advertisement Mode FT : Fault Tolerance

[PE1] display bgp peer

BGP local router ID : 3.3.3.9

Local AS number : 100

Total number of peers : 1 Peers in established state : 1

Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State

4.4.4.9 100 162 145 0 0 02:12:47 Established

[PE1] display isis peer

Peer information for ISIS(1)

----------------------------

System Id Interface Circuit Id State HoldTime Type PRI

0000.0000.0005 Vlan-interface12 001 Up 29s L1L2 --

2.

Configure the customer carrier network: start IS-IS as the IGP, and enable LDP between PE 3 and

CE 1, and between PE 4 and CE 2.

# Configure PE 3.