H3C Technologies H3C S10500 Series Switches - Manual (Page 358)

347
To do… Use the command… Remarks
Enable RIPng on the interface ripng process-id enable
Required
By default, RIPng is disabled on an
interface.
NOTE:
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between PE and CE
An OSPFv3 process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
Follow these steps to configure OSPFv3 between PE and CE:
To do… Use the command… Remarks
Enter system view system-view —
Create an OSPFv3 process for a
VPN instance and enter the
OSPFv3 view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
Required
Perform this configuration on PEs.
On CEs, create a normal OSPF
process.
Set the router ID router-id router-id Required
Return to system view quit —
Enter interface view
interface interface-type
interface-number
—
Enable OSPFv3 on the interface
ospfv3 process-id area area-id
[ instance instance-id ]
Required
By default, OSPFv3 is disabled on
an interface.
Perform this configuration on PEs.
NOTE:
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
Configuring IPv6 IS-IS between PE and CE
An IPv6 IS-IS process belongs to the public network or a single VPN instance. If you create an IPv6 IS-IS
process without binding it to a VPN instance, the process belongs to the public network.
Follow these steps to configure IPv6 IS-IS between PE and CE:
To do… Use the command… Remarks
Enter system view system-view —
Create an IPv6 IS-IS process for a
VPN instance and enter IS-IS view isis [ process-id ] vpn-instance
vpn-instance-name
Required
Perform this configuration on PEs.
On CEs, create a normal IPv6 IS-IS
process.
Configure a network entity title for
the IS-IS process
network-entity net
Required
Not configured by default