beautypg.com

Configuration on the p devices, Configuring svc mpls l2vpn, Configuration prerequisites – H3C Technologies H3C S10500 Series Switches User Manual

Page 205

background image

194

CAUTION:

You do not need to configure two static LSPs for each remote CCC connection. Instead, you must
configure the incoming and outgoing labels, where the incoming label must be exclusively for the CCC

connection. The labels function as static LSPs.

Only when the link that the outgoing interface connects is a point-to-point link, can you use the
out-interface keyword to specify the outgoing interface. If the link is not a point-to-point link but, for

example, a link connecting to Layer 3 Ethernet interface, VLAN interface, or Layer 3 aggregate

interface, you must use the nexthop keyword to specify the IP address of the next hop.

Configuration on the P devices

Perform the following configuration on a P device:

To do…

Use the command…

Remarks

Enter system view

system-view

Configure a transit static LSP

static-lsp transit lsp-name incoming-interface
interface-type interface-number in-label in-label

{ nexthop next-hop-addr | outgoing-interface
interface-type interface-number } out-label out-label

Required

CAUTION:

With CCC, no static LSPs are required on the PEs but dedicated bidirectional static LSPs are required on
all the P devices between the PEs for transmitting the data of the CCC connection.

For static LSP configuration commands, see

MPLS Command Reference.

Configuring SVC MPLS L2VPN

SVC MPLS L2VPN does not use any signaling protocol to transfer L2VPN information. Instead, it uses

tunnels to transport data between PEs.
SVC supports these tunnel types: LDP LSP and CR-LSP. By default, LDP LSP tunnels are used.

Configuration prerequisites

Before you configure SVC MPLS L2VPN, complete the following tasks:

Configure an IGP on the PEs and P devices to guarantee the IP connectivity of the MPLS backbone.

Configure basic MPLS and MPLS LDP for the MPLS backbone on the PEs and P devices to establish
LDP LSPs.

Enable MPLS L2VPN on the PEs.

Establish the tunnels between PEs according to the tunneling policy.

To configure SVC MPLS L2VPN, you need the following data:

Types and numbers of the interfaces connecting the CEs

Destination LSR ID of SVC

Incoming and outgoing labels of the L2VPN connection

SVC tunneling policy