H3C Technologies H3C S10500 Series Switches User Manual
Page 228
217
[PE2] interface ethernet1/1
[PE2-Ethernet1/1] port access vlan 10
[PE2-Ethernet1/1] service-instance 1000
[PE2-Ethernet1/1-srv1000] encapsulation s-vid 10
[PE2-Ethernet1/1-srv1000] xconnect peer 192.2.2.2 pw-id 1000
[PE2-Ethernet1/1-srv1000] quit
[PE2-Ethernet1/1] quit
5.
Configure CE 2.
[Sysname] sysname CE2
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
6.
Verify your configuration.
# Display the L2VPN connection information on PE 1 and PE 2. The output shows that an L2VC has been
established.
Display the L2VPN connection information on PE 1.
[PE1] display mpls l2vc
Total ldp vc : 1 1 up 0 down 0 blocked
Transport Client Service VC Local Remote
VC ID Intf ID State VC Label VC Label
1000 Eth1/1 1000 up 8193 8192
Display the L2VPN connection information on PE 2.
[PE2] display mpls l2vc
Total ldp vc : 1 1 up 0 down 0 blocked
Transport Client Service VC Local Remote
VC ID Intf ID State VC Label VC Label
1000 Eth1/1 1000 up 8192 8193
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/68/94 ms