beautypg.com

Configuring rsvp authentication, Configuring rsvp-te gr – H3C Technologies H3C S10500 Series Switches User Manual

Page 118

background image

107

To do…

Use the command...

Remarks

Enable resource reservation
confirmation

mpls rsvp-te resvconfirm

Required
Disabled by default

NOTE:

Reservation confirmation is initiated by the receiver, which sends the Resv message with an object
requesting reservation confirmation.

Receiving the ResvConf message does not mean resource reservation is established. It only indicates that
resources are reserved on the farthest upstream node where the Resv message arrived and the resources
can be preempted.

Configuring RSVP authentication

RSVP adopts hop-by-hop authentication to prevent fake resource reservation requests from occupying

network resources.
It requires that the interfaces at the two ends of a link must share the same authentication key to exchange

RSVP messages.
Follow these steps to configure RSVP authentication:

To do…

Use the command...

Remarks

Enter system view

system-view

––

Enter interface view of MPLS TE link

interface interface-type
interface-number

––

Enable RSVP authentication

mpls rsvp-te authentication { cipher
| plain } auth-key

Required
Disabled by default

NOTE:

Do not configure both FRR and RSVP authentication on the same interface.

Configuring RSVP-TE GR

The RSVP-TE GR function depends on the extended hello capability of RSVP-TE. Enable the extended hello

capability of RSVP-TE before configuring RSVP-TE GR.
Follow these steps to configure RSVP-TE GR on each device to act as the GR restarter or a GR helper:

To do…

Use the command...

Remarks

Enter system view

system-view

Enter MPLS view

mpls

Enable global RSVP hello
extension

mpls rsvp-te hello

Required
Disabled by default

Enable MPLS RSVP-TE GR

mpls rsvp-te graceful-restart

Required
Disabled by default

Set the RSVP-TE GR restart timer

mpls rsvp-te timer graceful-restart
restart restart-time

Optional
120 seconds by default