beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 287

background image

276

[PE2-LoopBack0] ip address 3.3.3.9 32

[PE2-LoopBack0] quit

[PE2] interface vlan-interface 12

[PE2-Vlan-interface12] ip address 172.2.1.2 24

[PE2-Vlan-interface12] quit

[PE2] ospf

[PE2-ospf-1] area 0

[PE2-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255

[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0

[PE2-ospf-1-area-0.0.0.0] quit

[PE2-ospf-1] quit

After the configurations, P establishes an OSPF adjacency with PE 1 and PE 2 respectively. Issue the
display ospf peer command. The output shows that the adjacency status is Full. Issue the display ip

routing-table command. The output shows that the PEs have learned the routes to the loopback interfaces

of each other. Take PE 1 as an example:

[PE1] display ip routing-table

Routing Tables: Public

Destinations : 8 Routes : 8

Destination/Mask Proto Pre Cost NextHop Interface

1.1.1.9/32 Direct 0 0 127.0.0.1 InLoop0

2.2.2.9/32 OSPF 10 1 172.1.1.2 Vlan13

3.3.3.9/32 OSPF 10 2 172.1.1.2 Vlan13

127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0

127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0

172.1.1.0/24 Direct 0 0 172.1.1.1 Vlan13

172.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0

172.2.1.0/24 OSPF 10 1 172.1.1.2 Vlan13

[PE1] display ospf peer verbose

OSPF Process 1 with Router ID 1.1.1.9

Neighbors

Area 0.0.0.0 interface 172.1.1.1(Vlan-interface13)'s neighbors

Router ID: 172.1.1.2 Address: 172.1.1.2 GR State: Normal

State: Full Mode:Nbr is Master Priority: 1

DR: 172.1.1.1 BDR: 172.1.1.2 MTU: 0

Dead timer due in 38 sec

Neighbor is up for 00:02:44

Authentication Sequence: [ 0 ]

Neighbor state change count: 5

2.

Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs.

# Configure PE 1.

[PE1] mpls lsr-id 1.1.1.9

[PE1] mpls

[PE1-mpls] quit

[PE1] mpls ldp

[PE1-mpls-ldp] quit

[PE1] interface vlan-interface 13

[PE1-Vlan-interface13] mpls

[PE1-Vlan-interface13] mpls ldp