beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 345

background image

334

[PE2-ospf-100-area-0.0.0.1] quit

[PE2-ospf-100] quit

[PE2] bgp 100

[PE2-bgp] ipv4-family vpn-instance vpn1

[PE2-bgp-vpn1] import-route ospf 100

[PE2-bgp-vpn1] import-route direct

[PE2-bgp-vpn1] quit

[PE2-bgp] quit

After completing the configurations, issue the display ip routing-table vpn-instance command on the PEs,
you can see that the path to the peer CE is along the OSPF route across the customer networks, instead

of the BGP route across the backbone. Take PE 1 as an example:

[PE1] display ip routing-table vpn-instance vpn1

Routing Tables: vpn1

Destinations : 5 Routes : 5

Destination/Mask Proto Pre Cost NextHop Interface

20.1.1.0/24 OSPF 10 1563 100.1.1.1 Vlan11

30.1.1.0/24 OSPF 10 3125 100.1.1.1 Vlan11

100.1.1.0/24 Direct 0 0 100.1.1.2 Vlan11

100.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0

120.1.1.0/24 OSPF 10 3126 100.1.1.1 Vlan11

4.

Configure a sham link

# Configure PE 1.

[PE1] interface loopback 1

[PE1-LoopBack1] ip binding vpn-instance vpn1

[PE1-LoopBack1] ip address 3.3.3.3 32

[PE1-LoopBack1] quit

[PE1] ospf 100

[PE1-ospf-100] area 1

[PE1-ospf-100-area-0.0.0.1] sham-link 3.3.3.3 5.5.5.5 cost 10

[PE1-ospf-100-area-0.0.0.1] quit

[PE1-ospf-100] quit

# Configure PE 2.

[PE2] interface loopback 1

[PE2-LoopBack1] ip binding vpn-instance vpn1

[PE2-LoopBack1] ip address 5.5.5.5 32

[PE2-LoopBack1] quit

[PE2] ospf 100

[PE2-ospf-100] area 1

[PE2-ospf-100-area-0.0.0.1] sham-link 5.5.5.5 3.3.3.3 cost 10

[PE2-ospf-100-area-0.0.0.1] quit

[PE2-ospf-100] quit

After completing the configurations, issue the display ip routing-table vpn-instance command again on
the PEs, you can see that the path to the peer CE is now along the BGP route across the backbone, and

that a route to the sham link destination address is present. Take PE 1 as an example:

[PE1] display ip routing-table vpn-instance vpn1

Routing Tables: vpn1

Destinations : 6 Routes : 6