H3C Technologies H3C S10500 Series Switches - Manual (Page 158)

147
LSP Information: RSVP LSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 1024/3 Vlan4/Vlan5
Perform the display mpls te tunnel command on each switch. You can see that two MPLS TE tunnels are
traversing Switch B and Switch C.
[SwitchA] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 4.4.4.4 -/Vlan1 Tunnel4
[SwitchB] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 4.4.4.4 Vlan1/Vlan2 Tunnel4
2.2.2.2:1 3.3.3.3 -/Vlan4 Tunnel5
[SwitchC] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 4.4.4.4 Vlan2/Vlan3 Tunnel4
2.2.2.2:1 3.3.3.3 Vlan5/- Tunnel5
[SwitchD] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 4.4.4.4 Vlan3/- Tunnel4
[SwitchE] display mpls te tunnel
LSP-Id Destination In/Out-If Name
2.2.2.2:1 3.3.3.3 Vlan4/Vlan5 Tunnel5
Perform the display mpls lsp verbose command on Switch B. You can see that the bypass tunnel is bound
with the protected interface VLAN-interface 2 and is currently unused.
[SwitchB] display mpls lsp verbose
-------------------------------------------------------------------
LSP Information: RSVP LSP
-------------------------------------------------------------------
No : 1
IngressLsrID : 1.1.1.1
LocalLspID : 1
Tunnel-Interface : Tunnel4
Fec : 4.4.4.4/32
Nexthop : 3.1.1.2
In-Label : 1024
Out-Label : 1024
In-Interface : Vlan-interface1
Out-Interface : Vlan-interface2
LspIndex : 4097
Tunnel ID : 0x22001
LsrType : Transit
Bypass In Use : Not Used
BypassTunnel : Tunnel Index[Tunnel5], InnerLabel[1024]
Mpls-Mtu : 1500
No : 2
IngressLsrID : 2.2.2.2