H3C Technologies H3C S10500 Series Switches - Manual (Page 51)

40
To do… Use the command… Remarks
Display information about BGP
VPNv6 peers established between
PEs
display bgp vpnv6 all peer [ ipv4-address
verbose | verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display information about IPv6
BGP peers established between the
PE and CE in a VPN instance
display bgp vpnv6 vpn-instance
vpn-instance-name peer [ ipv6-address
verbose | verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display all BGP VPNv6 routing
information
display bgp vpnv6 all routing-table
[ network-address prefix-length
[ longer-prefixes ] | peer ip-address
{ advertised-routes | received-routes }
[ statistic ] | statistic ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display the BGP VPNv6 routing
information of a specified RD
display bgp vpnv6 route-distinguisher
route-distinguisher routing-table
[ network-address prefix-length ] [ | { begin
| exclude | include } regular-expression ]
Available in any view
Display the BGP VPNv6 routing
information of a VPN instance
display bgp vpnv6 vpn-instance
vpn-instance-name routing-table
[ network-address prefix-length
[ longer-prefixes ] | peer ipv6-address
{ advertised-routes | received-routes } ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
NOTE:
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
IPv6 MCE configuration examples
Using IPv6 ISIS to advertise VPN routes to the PE
Network requirements
As shown in Figure 11 , the MCE device is connected to VPN 1 through VLAN-interface 10 and to VPN
2 through VLAN-interface 20. RIPng is used in VPN 2.
Configure the MCE to separate routes from different VPNs and advertise VPN routes to PE 1 through
OSPFv3.