beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 367

background image

356

[P-LoopBack0] ip address 2.2.2.9 32

[P-LoopBack0] quit

[P] interface vlan-interface 13

[P-Vlan-interface13] ip address 172.1.1.2 24

[P- Vlan-interface13] quit

[P] interface vlan-interface 12

[P-Vlan-interface12] ip address 172.2.1.1 24

[P-Vlan-interface12] quit

[P] ospf

[P-ospf-1] area 0

[P-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255

[P-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255

[P-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0

[P-ospf-1-area-0.0.0.0] quit

[P-ospf-1] quit

# Configure PE 2.

system-view

[PE2] interface loopback 0

[PE2-LoopBack0] ip address 3.3.3.9 32

[PE2-LoopBack0] quit

[PE2] interface vlan-interface 12

[PE2-Vlan-interface12] ip address 172.2.1.2 24

[PE2-Vlan-interface12] quit

[PE2] ospf

[PE2-ospf-1] area 0

[PE2-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255

[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0

[PE2-ospf-1-area-0.0.0.0] quit

[PE2-ospf-1] quit

After you complete the configurations, OSPF adjacency are established between PE 1, P, and PE 2. Issue

the display ospf peer command. The output shows that the adjacency status is Full. Issue the display ip
routing-table command. The output shows that the PEs have learned the routes to the loopback interfaces

of each other. The following takes PE 1 as an example:

[PE1] display ip routing-table

Routing Tables: Public

Destinations : 9 Routes : 9

Destination/Mask Proto Pre Cost NextHop Interface

1.1.1.9/32 Direct 0 0 127.0.0.1 InLoop0

2.2.2.9/32 OSPF 10 1 172.1.1.2 Vlan13

3.3.3.9/32 OSPF 10 2 172.1.1.2 Vlan13

127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0

127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0

172.1.1.0/24 Direct 0 0 172.1.1.1 Vlan13

172.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0

172.1.1.2/32 Direct 0 0 172.1.1.2 Vlan13

172.2.1.0/24 OSPF 10 1 172.1.1.2 Vlan13

[PE1] display ospf peer verbose

OSPF Process 1 with Router ID 1.1.1.9