beautypg.com

Configuring routing between pes – H3C Technologies H3C S10500 Series Switches User Manual

Page 263

background image

252

NOTE:

Exchange of BGP routes of a VPN instance is the same as that of ordinary BGP routes.

The BGP configuration task in BGP VPN instance view is the same as that in BGP view. For more
information, see

Layer 3—IP Routing Configuration Guide.

For information about BGP peer and BGP peer group configuration, see

Layer 3—IP Routing

Configuration Guide. This chapter does not differentiate between peer and peer group.

Configuring routing between PEs

Perform the following configurations on PEs.
Follow these steps to configure routing between PEs:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter BGP view

bgp as-number Required

Configure the remote PE as the
peer

peer { group-name | ip-address }
as-number as-number

Required

Specify the source interface for
route updates

peer { group-name | ip-address }
connect-interface interface-type

interface-number

Required
By default, BGP uses the source
interface of the optimal route

update packet.

Enter BGP-VPNv4 subaddress
family view

ipv4-family vpnv4

Required

Enable the exchange of
BGP-VPNv4 routing information

with the specified peer

peer { group-name | ip-address }
enable

Required
By default, BGP peers exchange
IPv4 routing information only.

Configuring routing features for BGP VPNv4 subaddress family

With BGP VPNv4 subaddress family, there are a variety of routing features that are the same as those for

BGP IPv4 unicast routing. You can select any of the features as required.

Configuring common routing features for all types of subaddress families

For VPN applications, BGP address families include BGP VPN-IPv4 address family, BGP-L2VPN address

family, and VPLS address family. Every command in the following table has the same function on BGP
routes for each type of the address families and only takes effect for the BGP routes in the address family

view where the command is executed.
Follow these steps to configure common routing features for all types of subaddress families:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter BGP view

bgp as-number Required

Configure the remote PE as the
peer

peer ip-address as-number
as-number

Required